User's Manual

IMPULSE
™
LTX Multimedia Whiteboard
24 Impulse Whiteboard Operation
To connect and set up a projector:
1 Locate a projector video cable and connect it to the Impulse
control panel projector connector inside the lower left door.
2 Connect the video cable to the projector.
3 Connect the projector’s power cord to an outlet.
4 Turn on the projector and move the projector so that the image
projects squarely onto your whiteboard. The projected image
need not fill the white area completely.
OPERATING YOUR LAPTOP FROM THE IMPULSE BOARD
To project the computer screen onto the board:
1 Assure that your laptop is generating video signal. (You may
need to press Fn - F5 or Fn - F8 on your laptop to enable video
output.)
LTX_UG_5.fm Page 24 Friday, June 13, 2003 11:02 AM