User's Manual

Impulse Whiteboard Operation 11
adapter connected to the same local area network (LAN) as the
Impulse system.
The wireless color printer receives its data using Bluetooth  wireless
technology. The Impulse system emits radio signals to the printer’s
antenna, so no physical connection is required between them. The
printer should be within 30 feet (10m) of the Impulse board, but it
does not need to be in the same room. If a wall is between Impulse
board and the printer, the antenna range may be reduced.
To print an image of the board:
1 Be sure the printer is turned on, and has paper and ink.
2 When you are ready to capture, press Printer once for each copy
you want to print. You will hear an audible message state “one
copy,” “two copies,” and so on for each copy.
3 Continue your presentation. The Printer LED flashes green until
printing is complete.
CAPTURING IMAGES ON A FLOPPY DISKETTE
You can capture an image of the board on a floppy diskette as an
Adobe® Acrobat© PDF file (.pdf). One floppy diskette holds 10 to 15
images (or as few as one, if a projected image is also captured),
depending on the complexity of the images. Files are named with the
date and time of capture.
The Impulse system uses only formatted MS-DOS high-density 3.5"
floppy diskettes. Formatted floppy diskettes are available from most
office supply stores.
Quick Capture
Printer Disk Website / Archive
A CCESS N UMBER
Password Protection
IP
LTX_UG_5.fm Page 11 Friday, June 13, 2003 11:02 AM