Use and Care Manual

Back Panel (1PC)
(F)
STEP-BY-STEP ASSEMBLY:
A: Le & Right Legs 2Pcs
B: Curved Runner 2Pcs
C: Back Leg Connecting
Bar 1Pc
D: Front Leg Connecting
Bar 1Pc
E: Top Leg Connecting
Bar 1Pc
F: Back Panel 1Pc G: Seat 1Pc
H: M6*95mm Screws 4Pcs
I: M6*50mm Bolts 12Pcs
J: Allen Wrench 1Pc
L
R
R
L
A
Part G
Part E
C
Part
Part D
Part B
STEP 1: Attach Left & Right Legs (A) to the Curved
Runners (B) using 2x M6*95 mm Screws (H) on each
side as pictured.
STEP 2: Attach the Front Leg Connecting Bar (D),
Back Leg Connecting Bar (C), Back Panel (F) to the
Left Leg (A) using 4x M6*50mm Bolts (I).
STEP 3: Attach the Seat (G) to the
Left Leg (A) using 2x M6*50mm Bolts (I)
as pictured.
STEP 4: Attach the Right
Leg (A) to Seat (G) using 2x
M6*50mm Bolts (I) as pictured.
STEP 5: Repeat step 2, but on
the Right Leg (A).
Insert one side of the Top Back Panel Bar (F) into the
Left Leg (A) to attach as pictured.
The other side of the Top Back Panel
Bar (F) should connect to the Right
Leg (A) without any bolt. Tighten and
secure all bolts.
Make sure the short side of the Seat
(G) is towards the back of the
armrest, while the longer side is at the
front.
E
I
I
I
F
D
G
I
I
I
I
I
I
I
I
H
H
H
H
A
A
B
B
*IMPORTANT NOTE: DO NOT OVERTIGHTEN THE BOLTS*
Make sure the longer side of both Curved Runners (B) is
towards the back of the armrests.
Tighten all bolts and screws after
assembly is complete.
C