Installation Guide

3. Cut 2 wood supports to be installed vertically

in the opening made from step 2. Cut wood

supports 4 inches longer than the vertical

opening measurement. Once cut, place the wood

supports on the backside of the wallboard

centered in the opening, with half of the wood

support exposed to the opening. Secure wood

supports in the wallboard using non-corrosive

screws, which are to be approx 6” apart on both

vertical sides of the opening.

4. Place PolyNiche into the wall with the opening side

facing out. Gently push PolyNiche into position until

the frame of PolyNiche sits at against the vertical

wood supports. PolyNiche should now be ush with

the ½” wallboard.

5. Ensure PolyNiche is ush with the ½” wallboard,

and sitting at against the vertical wood supports.

Using non-corrosive screws, secure PolyNiche in place

with the fasteners, which should be approx 6” apart.

The Smithson Company, Inc.

561.312.4088 | Info@Smithsoncompany.com | smithsoncompany.com

125 S. State Rd. 7 | Suite 104-174 | Wellington, FL 33414

POLYNICHE INSTALLATION