User's Manual

Version 1.1 – May 2005
Doc # 2520 Polymap Wireless Confidential and Proprietary.
2) Plug the jack into the bottom of the OneTouch Ultra unit, being careful to press
the connector firmly in place
3) Insert the 28L battery into the module. Please observe correct polarity or the
device will not function correctly.
4) Close the zippered case. The module is ready to use.
Appearance:
Figure 2: PWR-07-03 with its battery.
Usage
Take a measurement as you normally would. When the test strip is removed, the red
indicator light will turn on, and the glucose meter will display “PC”. This is normal, and
can be ignored. Both the light, and, eventually, the “PC” indication, will turn off on their
own. There is nothing the user need do other than take the measurements themselves.
Indicator light
The device incorporates a small red LED. This indicator will light shortly after you
remove a test strip from the glucose meter. It will turn itself off after the data is
successfully transmitted. Should the data fail to transmit immediately, the device will
schedule multiple retries, and the light may remain on as long as a half hour. Please note
that any measurements not transmitted immediately are stored and transmitted along with
later measurements.