User's Manual

Polytel
®
Data Transmission System
8-1500-R - 20 -
electrical medical devices. To ensure electromagnetic compatibility (EMC) the device
must be installed and operated according to the information provided in this manual.
NOTE: the entire Polytel® Data Transmission System wit all its components has been
tested to comply with IEC 60601-1-2:2001 requirements for EMC with other devices.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device , pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the following measures:
• Reorient or locate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
7.4 System Availability
The PWR-08-03 is designed to attempt delivery of each measurement from the host for
several minutes after a measurement is taken. The system is immediately available to
retrieve additional measurements in the case where they are taken before the previous
measurement(s) have been transmitted.
The PWA-08-01 Access Point is always available to receive measurements from measuring
devices, and will store them until it is able to forward them to your service provider
7.5 Dimensions of your PWA-08-01 Access Point
144mm x 97mm x 27mm (5.67 inches x 3.81 inches x 1.06 inches
7.6 Dimensions of your PWR-08-03 accessory:
72mm x 20mm x 45mm (2.85 inches x 0.8 inches x 1.8 inches)
8 Trademarks
Bluetooth
®
word mark and logos are owned by the Bluetooth SIG, Inc.
Polytel
®
is a registered trademark of Polymap Wireless LLC.
This product was designed solely by Polymap Wireless, independent of any of the host
device manufacturers