Manual

5
3) Prepare the filament
4) Start the print
5) Post process
When the print begins make sure the first layer is correctly laid down and
sticking well to the bed before leaving the printer to finish the print.
PolyLite™ ASA can be wet sanded to obtain a smoother surface.
PolyLite™ ASA can be chemically smoothed with acetone. We highly
recommend to use our PolySmooth™ filament for this purpose as it can
be smooth with IPA which is safer to manipulate than acetone.
- Carefully open the resealable bag, remove the spool and close the bag
back to preserve the desiccant bag.
- It is recommended to store PolyLite™ ASA in the PolyBox™ to prevent
moisture absorption which will lower the quality and the mechanical
properties of the print.
- Load the filament in your printer and wait until you have a consistent
extrusion.
- At the end of the print, make sure to correctly store the filament back in
the resealable bag if you are not using the PolyBox™.