Manual

4
My first print
1) Prepare the gcode
2) Prepare the printer
Download the MyFirstPrint.stl on www.polymaker.com
Load the stl file in your favorite slicer.
- Clean the build plate and prepare it with the right surface:
We recommend to print PolyLite™ ASA on BuildTak® or using Magigoo.
- Level the build plate.
- It is recommended to clean the nozzle when you change the material to
prevent partial clog.
Note: It is recommended to use an enclosure to print PolyLite™ ASA to prevent warping issue.
It is recommended to place the printer in a well ventilated area.
Enter the correct settings for PolyLite™ ASA;
Property Value
Bed temperature 75˚C-95˚C
Cooling fan OFF
Nozzle speed 30mm/s – 50mm/s
Nozzle temperature 240˚C-260˚C
Layer height 0.1
Number of outlines (shell) 3
Infill 20%
Top/Bottom layers
Surface adhesion
4
Brim or Raft