Information

3) Prepare the filament
4) Start the print
5) Post process
When the print begins, make sure the first layer is correctly laid down
and sticking well to the bed before leaving the printer to finish the print.
PolyMax™ PC can be annealed right after the printing process at 100˚C
for 2 hours to release residual internal stress and therefore preserve its
mechanical properties.
PolyMax™ PC can be sanded to obtain a smoother surface.
- Carefully open the resealable bag, remove the spool and close the bag
back to preserve the desiccant bag.
- It is recommended to store PolyMax™ PC in the PolyBox™ to prevent
moisture absorption which will lower the quality and the mechanical
properties of the print.
- Load the filament in your printer and wait until you have a consistent
extrusion.
- At the end of the print, make sure to correctly store the filament back in
the resealable bag if you are not using the PolyBox™.