Phau Ntawv Qhia

PH04 Comfort XLT Flushing - June 2019
Page 7 of 15
• Please follow directions in the sequence they are presented. It is suggested you read through the entire as-
sembly instructions prior to proceeding.
• Proper handling is required, especially structures that have at oors with minimal foundations. Dropping
this unit during transport and site set-up may cause structural damage or misalignment of the front assembly
and door.
• Position on clear level ground, shims may be used under the oor to aid in leveling, or the door may be out
of alignment.
• The PH04 Model restroom assembly will require two people.
• All drilling with 13/64” and 1/4” drill bits. All rivet holes drilled 13/64” dia.
• All references to left, right, front and rear throughout the entire assembly instructions are as viewed from the
front of the restroom.
GENERAL OVERVIEW
(12) PC-000105 Rivet
Small Flange
FULL SIZE SCALE FASTENER DRAWINGS
(3) PC-000104 Rivet
Small Flange, Long
(123) PC-000106
Washer
3/16” Back-up
(1) PC-000117 Rivet
Hollow Wall 3/4” Grip
(27) PC-000121 Washer
1/4” x 1-1/4” Fender
(29) PC-000123 Washer
1/4” x 5/8” Flat
(30) PC-000140
Nut 1/4”-20 Nylok
(4) PC-000175 Screw
1/4”-20 x 1-1/2” Phillips
(1) PC-000168 Washer
5/16” x 7/16” Flat
(113) PC-000100 Rivet
Large Flange, Short
~~Tools Required for Assembly~~
(23) PC-000139 Bolt
1/4”-20 x 1” Hex Head
(1) PC-000122 Screw
1/4”-20 x 2-1/4” TrussHead
(2) PC-000174 Bolt
1/4”-20 x 1-1/4” Hex Head
• 13/64” Drill Bit • 1/4” Drill Bit • Tapered Awls
• Rivet Gun w/ 3/16” nose piece • Phillips & Slotted Screwdriver • Hammer
• Tape Measure • (2) 7/16” Wrenches • Vise-Grips (Locking Pliers)
(4) PC-000102 Rivet
Small Flange, Short
(1) PC-000147 Screw
#10 x 3/4” Phillips Head