Phau Ntawv Qhia

PH04 Comfort XLT Flushing - June 2019

Page 14 of 15

Step 14. Toilet Paper Dispenser

The double roll dispenser can be mounted in a location of your prefer-

ence based upon the accessories you have in the unit. Level the dis-

penser on the wall and use the four holes in the back of the dispenser

as a guide to mark the location for drill holes. Drill four 13/64” holes

into the drill spots just marked. Use awls to hold the T.P. Dispenser

in place. From outside of the unit rivet in place using (4) PC-000100

rivets and (4) PC-000106 back-up washers on the inside.

PC-000100 Rivet

4 Used in this step

PC-000106 Washer

4 Used in this step

Push the spring tube assembly into the hole in the center molded pocket of the door with the cable end towards the

hinged side of the door. Insert the tabs of the door closure retainer clip into the 2 pre-drilled holes as shown below.

Pivot the retainer clip into place while feeding the spring cable through the hole in the retainer clip. Rivet into place

with (2) PC-000105 rivets. Line up the cable clip in the center of the door jamb to the door closure retainer clip. From

inside the unit using a 13/64” bit, drill two holes into one side of the door jamb only. Rivet the cable clip to the door

jamb using (2) PC-000108 rivets. On the inside of the unit, place the top of a hammer against the cable clip. Place the

ball end of the spring cable in the claw of the hammer. Open the door while holding the hammer in position. Hold the

door open with your foot and clamp a vice-grip pliers on the cable where it comes out of the door. BE SURE TO CLAMP

DOWN TIGHT. Remove the cable from the claw of the hammer, close the door and place the end of the cable into the

slot of the cable clip. Open the door and remove the vice-grips.

Step 15. Door Closure Installation

PC-000105 Rivet

2 Used in this step

PC-000108 Rivet

2 Used in this step