Phau Ntawv Qhia

PH04 Comfort XLT Flushing - June 2019
Page 13 of 15
For Fresh Flush Sink: Place the sink assembly into the corner and tilt
the sink out so that the intake hose coming from the tank can be con-
nected to the back of the sink. Place a PC-000352 clamp over the
end of the hose, install the hose on the tting, and tighten the
clamp in place.
For All Sink Installation: Place the sink assembly into the
corner, inserting the sink drain hose into the correspond-
ing hole in the tank. With someone holding the sink tight
in the corner, have another person drill 5 - 13/64” holes
in the locations shown in the gure to the left. Be sure to
drill only through the side wall and only one wall of the sink
surround. Fasten in place using a PC-000106 washer on
the end of a PC-000105 rivet and rivet in place. Place a
PC-000147 screw through the hole in the sink foot pump
mounting plate and screw into the oor plate.
Step 11. Sink Installation
Two holes located on
corner, 34-1/2” from top of base,
centered in flat areas
Two holes on right side, located
13-1/2” from right vertical rib. Top
hole 3” up from horizontal rib. Bottom
hole located 34-1/2” from top of base.
One hole on rear panel
located 34-1/2” from top of base,
centered on vertical rib.
13-1/2”
11-1/2”
PC-000106 Washer
5 Used in this step
PC-000105 Rivet
5 Used in this step
PC-000147 Screw
1 Used in this step
Step 12. Soap Dispenser Installation
Remove the mounting plate from the soap dispenser: To do this, start by turning the
lid of the dispenser counterclockwise and remove. Then, push in the locking
tab at the rear of the dispenser and push up on the soap container,
separating the container from the mounting plate. Using the
mounting plate as a drill guide, drill 3 - 13/64” holes into the sink
surround in the location shown to the right. Rivet in place using
3 - PC-000105 rivets. Reassemble the dispenser.
Step13. Paper Towel Dispenser Installation
Open the Paper Towel dispenser by lifting out on the sides
of the lid and lifting up. Place the dispenser in the location
shown and using the holes as a drill guide, drill 4 - 13/64”
holes through the side. Rivet in place using PC-000100 riv-
ets from the outside with PC-000106 washers on the inside.
PC-000100 Rivet
4 Used in this step
PC-000105 Rivet
3 Used in this step
PC-000106 Washer
4 Used in this step