Phau Ntawv Qhia

PH04 Comfort XLT Flushing - June 2019
Page 12 of 15
Slide the vent stack up through the 4” hole of the roof and down
into the corresponding hole in the tank. Using a 13/64” drill bit,
drill a hole through the boss on the tank and through the vent
stack. Rivet into place with (1) PC-000117 rivet.
Step 8. Vent Stack Installation
PC-000117 Rivet
1 Used in this step
Mark the hole locations on the front of the door for the door handle by measuring up from
the bottom of the door by 31-1/2” and measuring in from the side of the
door by 1/2”. This is the location for the bottom mounting hole. Using a
drill with a 13/64” drill bit, drill a hole through the plastic of the door and
the rst wall of the steel door pillar. Rivet the door handle to the door using
a PC-000104 rivet through the bottom hole of the handle. Making sure
the handle is straight on the door, use the very top hole of the handle
as a drill guide and drill a 13/64” hole through only the outside wall
of the steel door pillar. Rivet in place using a PC-000104 rivet. To
mount the rotary latch, insert the PC-000122 Screw through a PC-
000121 washer and into the front of the door. Place the rotary latch,
another PC-000121 washer on the end of the screw and fasten in place
using a PC-000140 lock nut. Adjust the tightness of the screw to adjust
the ease of the latch movement.
Step 9. Door Handle and Rotary Latch
Align the three holes of the metal bracket on the door check cable to the holes in the top inside center of the
door so that the bracket angles toward the unit and the three holes line up with the holes in the bracket (as
shown). Rivet into place using (3) PC-000105 rivets. From the outside of the unit, insert a PC-000104 rivet
into the pre-drilled hole at the top of the door opening of the door jamb. Place the looped end of the door
check cable on the end of the rivet followed by (1) PC-000168 washer and (1) PC-000106 back-up washer.
Rivet in place.
Step 10 . Door Check Cable
PC-000104 Rivet
1 Used in this step
PC-000168 Washer
1 Used in this step
PC-000105 Rivet
3 Used in this step
PC-000106 Washer
1 Used in this step
PC-000104 Rivet
2 Used in this step
Drill hole
1/2” away
from the side
of the door
and 31-1/2”
from the
bottom
of the door
PC-000121 Washer
2 Used in this step
PC-000122 Screw
1 Used in this step
PC-000140 Nut
1 Used in this step