Assembly Instructions

OWNER′S MANUAL
11
Should you encounter any problems, contact Customer Service at [phone] from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
8. Carefully slide the Horizontal Beams 2
into the sleeves of the pool.
9. Connect the T-Fitting 4 to Horizontal Beam 2.
IMPORTANT: DO NOT go on to the next step until all of the
T-Fittings have been connected to all of the Horizontal Beams.
12. Look through the hole in the T-fitting, as you insert the Vertical
Leg rotate it until the buttons align with the holes and pop out,
locking the Vertical Leg in place. Do this for all Vertical Legs.
13. Go around and check all fittings, legs, and beams are
properly installed and secured in place. Make sure the
drain fitting is plugged securely and the cap is in place.
2
2
4
4
10. Insert the Pin 6 down through the top of the T-Fittings
until the Pin snaps into place on the lower side of the T-fitting.
6
11. Carefully slide the Vertical Legs 3 up through the belt that runs
around the middle of the pool.
Tips: For smaller pools without a belt, slide the vertical legs up
through the sleeves on the pool wall.
3
3
Note: Each vertical leg has a V-Shaped
Spring Pin 7 pre-installed. There is one
extra included with your pool parts.
14. Fill up the pool with about an inch (1”) [2.54cm] of water. Stop filling and smooth out all wrinkles from the pool floor, working from the center outwards,
so that it fills evenly.
Note: If more than one to two inches (1”-2”) [2.54cm-5.08cm] of water collects on any one side before the pool starts filling in the center, the pool
is not level enough, and must be corrected.
15. Install the filtration system as per its instruction manual.
16. Continue to fill the pool to approximately eight inches (8”) [20.32cm] below the top rim.