Installation Guide
Should you encounter any problems, contact the Customer Service at (888) 919-0070.
Extended operating days and hours during peak season requirements.
9 10
S
U
T
L
U
T
S
U
T
U
L
A
T
12
16
Make sure the drain fitting is plugged securely and the cap is in place
Start filling the pool with water until 1-inch of water is on the bottom, stop filling and
smooth wrinkles out of the bottom of the pool. Push outward from inside the pool
removing all wrinkles so that it fills evenly and flat. IF MORE THAN 1-2 INCHES OF
WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN THE
CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED, SEE "SITE
PREPARATION" ON PAGE 4.
Install the Filter pump by following the instructions in the "Swimming Pool Filter System
" owner's manual. Once the filter pump is installed, continue filling water into the pool.
When the water half filled, the top frame will tend to bend down at the middle. IT IS
ABSOLUTELY NORMAL. Continue to fill water to the optimal level, the frame will restore
to its normal shape.
13
14
15
EXPLODED VIEW