Assembly Instructions
Table Of Contents
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 1
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 2
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 3
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 5
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 4
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 6
FCC notices:
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Polygroup Trading Limited
Unit 606, Fairmont House, 8 Cotton Tree Drive, Central, Hong Kong
www
.polygroupstore.com
This device complies with ISEDC
Operation is subject to the following two
(2) this device must accept any interference,
undesired operation of the device.
ISEDC Statement
Le présent appareil est conforme aux CNR
radio exempts de licenceou standard.
L'exploitation est autorisée aux deux conditions
(2) l'utilisateur de l'appareil doit accepter tout
Déclaration de l’ISEDC
d'ISEDC applicables aux appareils
Équipement ICES-00
3 du brouilleur.
suivantes :
(1) l'appareil ne doit pas produire de brouillage,et
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement.
licence-exempt RSS standards or Interference
caussing Equipment standard ICES-00
3.
conditions:
(1) this device may not cause interference, and
including interference that may cause
The device is compliance with RF exposure
guidelines, users can obtain Canadian informa-
tion on RF exposure and compliance.
Après examen de ce matériel aux conformité ou
aux limites d’intensité de champ RF, les utilisateurs
peuvent sur l’exposition aux radiofréquences et la
conformité and compliance d’acquérir les informa-
tions correspondantes.
Page: 6 of 6