Assembly Instructions
Table Of Contents
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 1
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 2
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 3
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 5
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 4
- User Manual---TG90P4826D49,D50,D48_9' PRE-LIT ASPEN Micro Dot LED TREE_EN 6
1. Unplug adaptor from the wall outlet. Then remove all ornaments and decorations.
2. Disassemble the tree from the top to the bottom. Gently lift the center pole straight up to remove from the section
below , and fold all branches toward the pole. Continue until the lowest tree section is removed from the tree stand.
3. Close the protective caps on the poles to avoid damaging the internal parts. (See Fig. D)
4. Carefully place all tree sections into the shipping box and tape (not included) it shut.
5. Store your tree in a cool, dry place away from sunlight. Exposure to excessive heat or
humidity may damage your tree.
STORAGE INSTRUCTIONS
If Tree Does Not Illuminate / Some Bulbs Do Not Light or Flicker
1.
2. Turn the poles gently to ensure pole-to-pole connection is secured.
Loose Hinge Pin
1. Place the branch into the slot of the bracket.
2. Insert a new hinge pin (included) through the hole and secure with
a retainer washer (included). (See Fig. E)
TROUBLESHOOTING TIPS
3. Each tree section is numbered with a sticker. Please identify all sections before assembling.
4. Assemble the tree from the bottom to the top (See Fig. B). Remove protection cap, and insert the center pole into
the stand. Then slot together the remaining poles securely until the tree top is installed. Be sure that all cords are
free from branch hinges.
5. Plug the adaptor into the wall outlet (See Fig. B). Your entire tree should now be lit.
6. This is a Simple Shape™ tree and no shaping is required. Just slightly upsweep all tips (See Fig. C) and shift branches
Top view
Side view
Fig. C
Fig. D
Fig. E
Page: 2 of 6
This tree includes hinge pins/washers. If extra parts are needed, please contact our customer service center.
SPARE PARTS
Simply press the selector button to select from the following light
functions: 1. Clear Steady 2. Clear Fading 3. Multicolor Steady
4. Multicolor Fading 5. Clear / Multicolor Alternating
6. Clear / Multicolor Fading 7. Demo
DUAL COLOR LIGHT CONTROLLER INSTRUCTIONS
Remote Control
Selector
Button
BATTERY REPLACEMENT
1. Remove the insultation tab.
2. Loosen the screw of the battery cover with a screwdriver (not included).
Insulation Tab