Installation Instructions

SA CAP PRO
®
SELF-ADHERED SBS GRANULATED CAP SHEET
Copyright ©2016 by Polyglass U.S.A., Inc and all rights are reserved
Edition Date: 06/16 • Doc# HG-SACAPPRO
APPLICATION INSTRUCTIONS
SA Cap Pro is intended to be used as a cap sheet for new or re-roof applications as part of a multi-ply system when applied
to acceptable insulations and/or coverboards for commercial and residential structures. SA Cap Pro may also be applied
directly to approved wood deck substrates of non-occupied spaces such as carports, sheds, canopies, etc.
• Apply only when the weather and forecast is dry and the ambient air temperature and substrate is 40°F (5°C) and rising.
• Apply over clean, dry, dust and debris free substrates. Prime concrete decks prior to application with an asphalt primer.
• When re-roong, remove all prior roong materials down to a clean debris free substrate and properly close off all
abandoned roof penetrations.
• Concrete or steel decks shall be designed with proper expansion devices.
• Wood decks shall have all joints blocked and properly supported.
• Ensure the installation of SA Cap Pro does not prevent the ventilation of existing construction
• Do not apply over shingles or other granulated surface.
• While installing SA Cap Pro:
1. Start at the low point of the roof.
2. Unroll the material and allow to relax.
3. Start by removing the rst 18–24" of release lm.
4. Press the membrane into place with rm and even pressure. Roll the edges with a silicone hand roller to ensure
complete adhesion.
5. Gradually remove the remaining release lm applying pressure from the center to the edges as you go.
6. Position successive rolls providing a minimum 6" end lap and 4" side lap. Laps can be sealed for additional water
tightness with a hot air welder.
7. After installation of the entire roof surface, roll with an 80# split-face linoleum roller. Take care on sloped roofs by
securing the roller and applicator with the appropriate safety equipment.
• Details and ashing may be installed using SA Cap Pro with a hot air welder or with a Roof Cement. Check project details
for proper installation requirements.
MANUFACTURING FACILITIES
• Fernley, NV
• Hazleton, PA
• Phoenix, AZ
• Winter Haven, FL
CORPORATE HEADQUARTERS
Polyglass U.S.A., Inc.
1111 West Newport Center Drive
Deereld Beach, FL 33442
General Line: [phone]
[phone]
Customer Service: [phone]
Technical Service: [phone]
Questions? [e-mail]
Product Disclaimer: Unless otherwise incorporated into or part of a supplemental manufacturer’s warranty, Polyglass
warrants its product(s) against manufacturing defects in its product that directly results in leakage for a period of 2 years.
Refer to safety data sheet (SDS) for specic data and handling of our products. All data furnished refers to standard production and is given in good faith
within the applicable manufacturing and testing tolerances.
Polyglass U.S.A., Inc., reserves the right to improve and change its products at any time without prior notice. Polyglass U.S.A., Inc. cannot be held
responsible for the use of its products under conditions beyond its own control.
For most current product data, visit www.hydraguardroofproducts.com