User's Manual

- 9 -
Default setting
14. After step 13 above, DEFAULT 1NO shows on screen. No is factory set.
15. Use the number keys to enter the desired setting. For example, to choose Yes, press the
number 2 key. “2 YES” will restore or reset the phone to original factory settings.
16. Press the Flash/Program Button (11) to store selection. You will hear a confirmation
tone.
BASIC
Receiving a call
1. When the phone rings the screen shows caller information*.
2. Press the Talk Button (14).
*(If you do not subscribe to a caller ID service, there will be no information on display.)
There will be “NO DATA” on display.
Ringer switch
• The Ringer Switch (12) must be “ON” for the handset to ring during incoming calls.
Volume
• While talking, press the Caller ID/Volume ( and ) Button (7) to control the receiver
volume. There are four volume levels. Press to increase the volume level, and press
to decrease. VOL 1 is the lowest level and VOL 4 is the loudest.
Making a call
•Press the Talk Button (14) before you dial and press it again to hang up.
Redialing a call
•Press the Talk Button (14) and then the Redial Button (5) to redial the last number you
dialed (up to 32 digits). If you get a busy signal, and want to keep dialing the number, just
press the Redial Button (5) again (you do not have to turn the phone off and back on).
Pre-dialing
1. Make sure the phone is OFF (not in TALK mode).
2. Enter the telephone number. The telephone number shows on screen.
3. Press the Talk Button (14). The number is dialed automatically.
Note: You may enter up to 32 pre-dial digits.
Flash button
• Use the Flash/Program Button (11) for special calling services such as Call Waiting or
Call Transfer. You must subscribe to these services available through your local phone
company.
Tip: Do not use Talk Button (14) to activate custom calling services or you’ll hang up
the phone.
Voice mail/Charge/In-use indicator
• Flashes when you have a new voice mail.
• Lights when the handset is being charged
in the base.
• Lights when the handset is in use.
Voice mail
•When you subscribe to a voice mail service offered by your phone company, the phone
alerts you when voice mail has been received MESSAGE WAITING appears on screen
for 60 seconds when a voice mail is received. The Voice Mail/Charge/In-use Indicator
(22) on the base flashes to indicate there is voice mail waiting. After the voice mail has
been reviewed MSG WAITING OFF appears on screen and the Voice Mail/Charge/
In-use Indicator (22) stops flashing.
English
PAGE BUTTON