User's Manual

- 15 -
• Repeat caller. Indicates that a new call from the same number was received more than
once.
• No Caller ID information was received.
• Indicates a memory location is vacant.
• No new calls received.
• This appears for 60 seconds when you have just received a new voice mail. This message
only appears if you subscribe to an answering service with your telephone company.
• Appears when Voice Mail has been reviewed.
SOUND SIGNALS
Signal Meaning
A long warbling tone Signals an incoming call (with ringer on)
Two long beeps Confirmation tone
One short and one long beep Page signal
One short beep every 15 seconds Low battery warning
Error tone Three short beeps
Key feedback tone Enabled
Key tone Enabled
TROUBLESHOOTING
CALLER ID
No display on screen
• Is battery fully charged? Try replacing the battery. Make sure the battery is properly
installed and connected.
•Make sure that the phone is connected to a non-switched electrical outlet. Disconnect
the phone from the outlet and plug it in again.
• Did you subscribe to Caller ID service from your local telephone company?
Caller ID error message
• The phone displays this message if it detects anything other than valid Caller ID
information during the silent period after the first ring. This message indicates the presence
of noise on the line.
Voice Mail/In-use/Charge indicator flashes
•When you subscribe to a voice mail service from your phone company, the Voice Mail/
Charge/In-use Indicator (22) on the base flashes when the phone is not in use to indicate
there is a voice mail waiting. It stops flashing after the voice mail has been reviewed.
TELEPHONE
No dial tone
• Check all connections:
- Is the AC/DC adaptor connected to a working outlet?
- Is the telephone line cord connected to the base and the wall jack?
English