User's Manual

- Is the telephone line cord connected to the base and the wall jack?
 Disconnect the base from the wall jack and connect another phone to the same
jack. If there is no dial tone in the second phone, the problem might be your
wiring or local service.
 Is the handset out of range of the base?
 Make sure the battery is properly charged (12 continuous hours).
 Is the battery installed correctly?
 Does the handset beep when you press the Talk Button (14)? The battery may
need to be charged.
Dial tone is OK, but cannot dial out
 Make sure the tone/pulse setting is programmed correctly.
Handset does not ring
 Make sure the Ringer On/Off Switch (19) on the handset is turned to ON
position.
 You may have too many extension phones on your line. Try unplugging some
phones.
 See solutions for No dial tone.
You experience static, noise or fading in and out
 Change channels.
 Is handset out of range? Move closer to the base.
 Does the base need to be relocated?
 Charge battery.
 Make sure base is not plugged into an outlet with another household appliance.
Handse t beeps
 Place handset in base for 20 seconds to reset the security code. If that doesn’t
work, charge battery for 12 continuous hours.
 Clean charging contacts on handset and base with a soft cloth, or an eraser.
 See solutions for No dial tone.
 Replace battery.
Dialing from directory
 Did you program the memory locations of directory?
 Did you follow proper dialing sequence?
 Make sure the tone/pulse setting is programmed correctly.