System information

10–15
Configuring KIRK Wireless Server 6000
Configuring a KIRK Wireless Server 6000 Using DHCP
This section describes how to configure a KWS6000 using DHCP.
Note
It is strongly recommended to configure the KWS6000 using a static IP
address.
Note
If the KWS6000 is configured using DHCP, it is necessary to assign a
reservation for the device on the DHCP server.
For information on accessing the web based Administration Page, refer to
“Accessing the Web Based Administration Page” on page 10-3.
This section contains information about:
• “General Configuration” on page 10-15
• “Wireless Server Configuration” on page 10-16
• “Built-In Media Resource Configuration” on page 10-17
• “SIP Configuration” on page 10-17
• “Security Configuration” on page 10-17
General Configuration
Using DHCP the device requests and obtains an available IP address from a
DHCP server. The device also obtains other parameters such as the default
gateway, subnet mask, DNS server, Time server and other IP parameters from
the DHCP server.
1 Click Configuration, and then click General.