System information

10–12
KIRK Wireless Server 6000 Installation and Configuration Guide
3 The Transport field is set by default to UDP only, alternative is DNS SRV.
UDP only would be selected if SIP signalling is sent through UDP, and only
simple DNS is used for resolving IP addresses. DNS SRV would be selected
if SIP signalling is sent through UDP, and DNS SRV is used for solving IP
addresses.
4 In the Default Domain field, type the name of the domain.
Note:
If no user specific domain is configured, the handsets registered on
the KWS6000 will use the default domain as the domain part of the SIP
URI; e.g. John Doe <sip:[e-mail]>.
5 Select Register each endpoint on separate port check box (optional). If
enabled, it specifies that each user should use an individual UDP for its
signaling; if disabled, all users should use the local port defined in the SIP
configuration.
6 The Send all messages to current registrar check box (optional) specifies
how requests outside a dialog are sent if a list of SIP servers is received via
DNS SRV. If enabled, sends each request to the server currently holding the
registration; if disabled, performs a DNS SRV lookup for each request and
determines the destination from this.
7 In the Registation Expire(sec) field, type the number of seconds before a
SIP registration will be renewed.
The default value is 3600.
8 In the Max Forwards field, type a value (optional). It refers to the maximum
number of proxies or gateways jumps, maximum number of times the SIP
messages can be forwarded.
The default value is 70.
9 The SIP type of service (TOS/Diffserv) field defines the Network Type of
Service used for SIP messages.
The default value is 96.
10 In the Proxy field, type a SIP proxy (optional).
Note: The proxy is the SIP URI of the SIP-proxy. The KWS6000 will route
all outgoing SIP signalling to the proxy, e.g. SIP registrations and
outgoing calls.
Along with the firmware version PCS04_ there was added support for
entering more SIP proxies for failover and load balancing. This feature is
relevant in a setup with more than one SIP proxy.
11 In the Default User field, type the user name.
12 In the Default Password field, type the password (optional).