System information

Configuring KIRK Wireless Server 6000
10–9
Wireless Server Configuration
On the Configuration/Wireless Server page you configure the KWS6000 to
allow subscription. If the system does not allow subscription, it is not possible
to subscribe a handset.
1 Click Configuration, and then click Wireless Server.
Figure 10-8 Adm. Page WS: Configuration/Media Resource page
2 Select the Subscription Allowed check box (optional).
Note: If not selected, you cannot subscribe a handset.
3 Select the Authenticate Calls check box (optional). If selected,
authentification will be performed every time a call is established.
4 The Encypt voice/data field (optional) specifies if dect encryption should
be used for voice calls. It can be set as disabled, enabled or enforced (calls
are terminated if the handset does not support encryption).
Note: If dect encryption is enabled, the system requires base station
firmware version PCS04_ or higher and it will not be possible to use
repeaters on the system. Enabling encryption will additionally encrypt
voice with an encryption key; a new key will be calculated for each new
call.
5 Select the Autocreate Users check box (optional). If selected, after
subscribing a handset, the system automatically will create a user for that
specific handset, with the corresponding IPEI; afterwards, further details
can be added to that user.
6 The System access code field (optional) specifies a system wide DECT access
code required for subscribing handsets. The access code is from 0 to 8 decimal
digits. Access codes assigned for specific users will override this setting.
7 Select the Send date and time check box (optional). This feature makes it
possible to select whether the date/time should be visible in the handset or not.