System information

Installing KIRK Base Station
6–5
KIRK Base Station - Reset Button
It is possible to restart or reset the base station by pressing the Reset button on
the faceplate of the base station. For description of the faceplate, refer to
“Faceplate” on page 6-4.
Resetting the KIRK Base Station Hardware
This section contains a description of the different actions that take place when
pressing the Reset button.
Table 6-3 Reset Button Description
Press button Action
Short press (2 to 5 sec.) System restarts when button is
released.
Long press (5 to 9 sec.) until
front LED flashes red, then
release button
Resets the system to factory default
settings (original IP settings and
empty user data base) and restarts
the system.
Firmware version is not affected.
Installing the KIRK Base Station
The base station is suitable for mounting indoors on a wall.
Note
Before beginning the installation, determine the position of the base station
for best coverage. The coverage depends on the construction of the
building, architecture, and the choice of building materials. Refer to
“Environmental Requirements” on page 2-8 for more information about
environmental requirements for base stations.
Wall Mounted (Vertical) Installation RF Coverage
For best RF coverage, the base station must be mounted vertically on walls.
Caution:
The base station must not be installed at any angle other than vertical.