Network Card User Manual

Chapter 10 - Conference Templates – Full Parameters View
10-34
Chair Control Chair Control is an option that enables an endpoint
to control the conference and other conference
participants.
Select this check box to enable the Chair Control
mode. When the Chair Control option is enabled,
any participant with an H.243-compliant endpoint
can request the control during the conference. When
enabled, you cannot view any Chair-related
parameters in the Meeting Director window while the
conference is running (but can be monitored in the
MGC Manager application). For more information,
see the MGC Manager User’s Guide, Volume II.
Label You can assign a label to the conference by
selecting it from the drop-down list. Labels are used
to filter Conference templates. They are defined in
the MGC Web Server Manager application.
Message Service
Type
Select one of the following options:
None - No Attended services are used during the
audio only conference.
Welcome (No Wait) - select this option for a Greet &
Guide conference in which the participant is greeted
by an audio message and after a pre-defined period,
and automatically connects to the appropriate
conference.
Attended (Wait) - select this option for a attended
conference in which a participant is greeted by an
audio message, and then is assisted by the operator
who connects him/her to the appropriate conference.
IVR - The IVR Service enables control over the
conference from the participant or chairperson
endpoint using touch-tone codes (DTMF).
Select this option to assign an IVR Service to the
conference. This option can only be selected if an
Audio+ card is installed on the MCU.
If the IVR Service check box is cleared and the Entry
Queue Access check box (in the General tab) is
checked, the participant connects to the conference
directly from the Entry Queue.
Table 10-4: Advanced Conference Parameters
Option Description