User manual
Table Of Contents
- Table of Contents
- VoicePlus Overview
- Defining Standard Audio Only Conferences and Reservations
- Monitoring On Going Conferences
- General Monitoring
- Participants Queue
- Conference Level Monitoring
- Participant Level Monitoring
- Operations Performed During On Going Conferences
- Management Functions Overview
- Participant Level Operations
- Making Dial-Out Connections
- Changing Participant Connection Types (Dial-In/Dial-Out)
- Disconnecting Participants from Conferences
- Naming Undefined Dial-in Participants
- Changing the Disconnected Participant’s Properties
- Moving a Participant from one Conference to Another
- Designating an Exclusive Speaker
- Changing Participant’s Status to Conference Chairperson
- Designating a VIP Participant
- Adjusting Participant’s Broadcasting and Listening Volume
- Muting and Unmuting Participant’s Audio
- Enabling/Disabling Auto Gain Control (AGC)
- Modifying the Participant’s User Defined Properties
- Conference Level Operations
- Adding New Participants to a Conference
- Muting Dial-In Participants Upon Connection
- Adding Remarks During an On Going Conference
- Locking and Unlocking a Conference
- Managing Question-and-Answer Sessions
- Managing Voting Sessions
- Placing a Conference On Hold
- Modifying Conference General Parameters
- Changing the Conference Duration
- Ending a Conference before its Scheduled Termination Time
- Rescheduling Conference Reservations
- Deleting Recurring Reservations
- Printing Conference Data
- Managing Conferences Using DTMF Codes
- Meeting Rooms and Entry Queues
- IVR and Entry Queue Services
- Attended Conferencing
- Requirements for an Attended Conference
- Defining an Operator Conference
- Setting the Participants Connection to the Conference to Attended Mode
- Participants Queue Management
- Managing Attended Participants from the Browser, Status and Monitor Panes
- Recording
- Appendix A: Glossary
Chapter 2 - Defining Standard Audio Only Conferences and Reservations
2-6
MCU Configuration and Audio Only Conferences
The functional modules (cards) installed in the MCU determine what kind of
conference can run on the MCU.
The Audio+ card is required to run IVR-enabled conferences and Entry
Queue and Audio Only conferences. If no such card is available, an error
message is displayed when defining any of these conferences.
T1-CAS participants are supported only with the Audio+12/24, Audio+24/48
and Audio+48/96 cards.
It is not possible to mix an ISDN Network Service and a T1-CAS Network
Service on the same Net-2/Net-4/Net-8 Network Interface module. Therefore,
to run both ISDN and T1-CAS conferences simultaneously, you must install
two separate the Net-2/Net-4/Net-8 cards. IP or IP+ cards are required to run
conferences that include VoIP participants.
IP+ cards from version 4.23 or higher are required for conferences that
include SIP participants. IP (12 or 24) cards are sufficient for H.323-only
conferences.
The VTX 1000 connection is supported with the Audio+12/24, Audio+24/48
and Audio+48/96 cards and the MGC-25.