Network Router - Wireless Network Device User Manual
Table Of Contents
- Introduction
- Getting Started
- Configuring the V2IU 4350
- Configuration Guide For IP Centrex Applications
- Configuration Guide For Station Side IP PBX Applications
- Configuration Guide For Trunk Side IP PBX Applications
- Configuration Guide For Hosted Video Applications
- Configuration Guide For Enterprise Video Applications
- System Configuration
- Read-only User
- Subinterfaces
- ToS Byte Setting
- H.323 Configuration
- Forwarding Rules
- Peering Proxy
- Clients List Lock
- H.323 Activity Monitor
- VoIP Configuration
- Data Networking Configuration
- Traffic Management Configuration
- System Diagnostics
- Saving and Restoring the V2IU 4350 Configuration
- Upgrading the V2IU 4350
- Appendix
- Regulatory Notices
6 - 1
6
Upgrading the V
2
IU 4350
This chapter describes how to upgrade your 4350 to the latest software release
available from Polycom.
It is recommended that you reboot the 4350 prior to performing the upgrade.
This is to make sure there is enough dynamic memory available to handle the
upgrade process.
Upgrade Procedure for Software Revision 1.3.11 or Later
Use this procedure if your 4350 is running software revision 1.3.11 or later. The
software version can be found on the System page of the web GUI.
1. Select System.
2. Select System Overview.
3. Select Upgrade firmware.
Warning
When you update your software telephone services will be unavailable for several
minutes. It is therefore advised that upgrades be performed during a maintenance
window when telephone traffic can be interrupted.