User manual

6
1 In the Fast Configuration Wizard - IP dialog box, define the following
parameters:
2 Click Next.
3 In the Fast Configuration Wizard - Routes dialog box, enter the IP
address of the default router.
4 Click Next.
5 Enter the required DNS information in the dialog box.
Field Description
IP Service
Name
Use the default name (Default IP Service) or enter a name
using up to 20 characters.
Note: This field is displayed in all dialog boxes.
Signaling Host
IP Address
Enter the IP address of the Central Signaling host. This is
the address used by endpoints for dialing in to the MCU.
MPM/MPM+ 1
IP Address
Enter the IP address(es) of the media card (s) (MPM/
MPM+ 1 and MPM/MPM+ 2 (if installed)) as provided by
the network administrator. Endpoints connect to
conferences and transmit call media (video, voice and
content) via these addresses.
MPM 2/MPM+
IP Address
Subnet Mask Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
If Secured Communication is required on the RMX: complete the
Fast Configuration Wizard, Login, install the Certificate and then
enable the Secured Communication Mode.
Field Description
MCU Host Name Enter the name of the MCU on the network.
Default name is RMX