User manual

18 Click Next.

19 In the PRI Settings dialog box, define the following parameters:

Span Type Select the type of spans (ISDN/PSTN) lines,

supplied by the service provider, that are connected

to the RMX. Each span can be defined as a

separate Network Service, or all the spans from the

same carrier can be defined as part of the same

Network Service.

Select either:

• T1 (U.S. – 23 B channels + 1 D channel)

• E1 (Europe – 30 B channels + 1 D channel)

Default: T1

Note: Only one Span Type (E1 or T1) is supported

on the RMX. If you define the first span as type E1

all other spans that you may later define must also

be of type E1.

Service Type PRI is the only supported service type. It is

automatically selected.

Field Description

Default Num Type Select the Default Num Type from the list.

The Num Type defines how the system handles the

dialing digits. For example, if you type eight dialing

digits, the Num Type defines whether this number is

national or international.

If the PRI lines are connected to the RMX via a

network switch, the selection of the Num Type is used

to route the call to a specific PRI line. If you want the

network to interpret the dialing digits for routing the

call, select Unknown.

Default: Unknown

Note: For E1 spans, this parameter is set by the

system.

Field Description