User's Manual

Polycom CMA System Operations Guide
126 Polycom, Inc.
VCR/DVD Record
Source
Specifies the video source to be recorded to videotape or
DVD.
• If Far is enabled, the recorded video will switch to the
current far site speaker.
• If both Near and Far are enabled, the recorded video
will switch between near and far sites depending on
the current speaker.
• If Content is enabled, any content sent during the call
is recorded.
Y——
Near Y——
Far Y——
Content Y——
Screen Saver Wait
Time
The time the system will delay before going into standby
mode after nonuse
Y
Cameras > Cameras 1
Camera 1 Name Specifies a name for camera 1. Y
Camera 1 Icon Specifies an icon for camera 1. Y
Camera 2 Name Specifies a name for camera 2. Y
Camera 2 Icon Specifies an icon for camera 2. Y
Cameras > Camera Settings
Camera 1 Name Specifies a name for camera 1. Y Y Y
Camera 1 Icon Specifies an icon for camera 1. Y Y Y
Camera 2 Name Specifies a name for camera 2. Y Y Y
Camera 2 Icon Specifies an icon for camera 2. Y Y Y
Camera 3 Name Specifies a name for camera 3. Y Y Y
Camera 3 Icon Specifies an icon for camera 3. Y Y Y
Cameras > Video Quality
Camera 1 Specifies Motion or Sharpness for the video input. The
default is Sharpness.
•Motion — This setting is for showing people or other
video with motion.
•Sharpness — The picture will be sharp and clear, but
moderate to heavy motion at low call rates can cause
some frames to be dropped. Sharpness is available in
point-to-point H.263 and H.264 calls only. It is
recommended for HD calls between 1 Mbps and 2
Mbps.
YY Y
Camera 2 YY Y
Camera 3 YY Y
Field For the endpoint systems being provisioned...
HDX Series V\VSX Series FX/EX ViewStation QDX Series