User's Manual

S01MGAINWB0,WM0,-3
Set crosspoint gain
in EF Bus submatrix
on crosspoint that
routes the W bus
signal from the
device at ID0 (WB0)
to W submatrix
output 0 (WM0).
S01MGAINWB0,WM0,-3
S01MGAIN1,*,ä{{èäÇÇÇÇÇ
Set all crosspoint
gains for input
channel 1. Set the
gain to output 1 to 0
dB (ä), the gain to
outputs A-B to -9 dB
({), the gain to the
telephone output to
6 dB (è), the gain to
AEC reference 1 to 0
dB (ä), and the gain
to bus outputs P, W,
X, Y, and Z to -3 dB
(Ç).
S01MGAIN1,*,ä{{èäÇÇÇÇÇ
S01MGAINB,*,-3
Set all crosspoint
gains for input
channel B to -3 dB.
S01MGAINB,*,ÇÇÇÇÇÇÇÇÇÇ
S01MGAINB,*,>12
Increase the gain for
all crosspoints of
input channel B by
12 dB.
S01MGAINB,*,abcdefghij , where the value
of each of letters (a, b, etc.) depends on the
current state of each of the crosspoint gains. If
this command was issued after the example
above, then the status message would be
S01MGAINB,*,èèèèèèèèèè
S01MGAINB,*,?
Query the gains for
all crosspoints of
input channel B .
S01MGAINB,*,abcdefghij , where the value
of each of letters (a, b, etc.) depends on the
current state of each of the crosspoint gains. If
this command was issued after the example
above, then the status message would be
S01MGAINB,*,èèèèèèèèèè
8.101. MGATE -- Select Gated or Ungated Microphone
Signal in Matrix
For each crosspoint of the microphone input channels of the main matrix, the microphone signals can
be taken before the automixer (ungated) or after the automixer (gated). This command selects the
gated or ungated microphone signal. If MGATE is set to 1 for a given crosspoint, then the signal will be
gated (taken after the automixer). If MGATE is set to 0 for a given crosspoint, then the signal will be
ungated (taken before the automixer).