User's Manual

Example Description Status Message
S01LIEN1
Enable automatic logic input status messages.
S01LIEN1
S01LIEN0
Disable automatic logic input status messages.
S01LIEN0
S01LIEN2
Toggle automatic logic input status messages.
S01LIENx , where x is 0 or 1 depending
on the current setting of LIEN.
S01LIEN?
Query automatic logic input status messages.
S01LIENx , where x is 0 or 1 depending
on the current setting of LIEN.
8.80. LIG -- Configure Logic Input Pins Into a Group
This conmmand configures which logic input pins are in a group. Logic groups allow events to happen
when certain combinations of inputs are present on the logic pins. For example, if a logic group was
defined that consisted of three logic input pins (pin 1, pin 2, and pin 3), then a total of eight
combinations (2
3
) are possible, and a command or macro can be assigned to each combination. This
feature is particularly useful in room-combining applications. It can also be used to make controls
based on rotary switches that output binary, BCD, or Gray codes.
Commands can be assigned to the configurations of a logic group via the
LIN command.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved
each time it is changed. It will retain its value after power-down. Since this command writes to non-
volatile memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
Configure
Logic Group
2 to contain
logic input
pins 5-8.
S01LIG2,01101001000010000000000
Configure
Logic Group
2 to contain
logic input
pins 2, 3, 5,
8, and 13.
Note that
the pins in a
logic group
do not have
to be
contiguous.
S01LIG2,01101001000010000000000
S01LIG2,?
Query which
pins are in
logic group
2.
S01LIG2,abcdefghijklmnopqrstuvwx
, where a-x are each 0 or 1 depending on
which logic input pins are assigned to logic
group 2.