User's Manual
Troubleshooting 
PN: 1725-36034-001_C.doc  93 
Message  Description  Action 
No Host IP (Addr) 
The handset is configured for “static 
IP” (as opposed to “use DHCP”) 
and no valid host IP address (the 
handset’s IP address) has been 
entered. 
Enter a valid IP address in the 
configuration settings or change to “use 
DHCP.” 
No IP Address  Invalid handset IP address. 
Check the IP address of the handset and 
reconfigure if required, or change to “use 
DHCP”. 
No Net Access 
Cannot communicate with LAN 
devices through the WLAN (such 
as PBX). 
Verify the AP connectivity to the LAN. 
Verify that all the WEP settings in the 
handset match those in the APs. 
No Net Found 
No APs 
Handset cannot find any APs 
This indicates any of the following: 
  No radio link. 
Verify that the AP is turned on. Verify 
WMM is enabled on AP. WMM is 
mandatory. 
No ESSID: Auto-learn not 
supported (or) incorrect ESSID. 
Verify the ESSID of the wireless LAN and 
enter or Auto learn it again if required. 
AP does not support appropriate 
data rates. 
Check the AP configuration. 
  Out of range. 
Try getting closer to an AP. Check to see 
if other handsets are working within the 
same range of an AP. If so, check the 
ESSID of this handset. 
  Incorrect Security settings. 
Verify that all the Security settings in the 
handset match those in the APs. 
No Net Found 
xxxxxxxxxxxx yy 
x…x = AP MAC address. 
yy = AP signal strength. 
Handset cannot find a suitable AP; 
displays MAC and signal strength 
of “best” non-suitable AP found. 
Check AP and handset network settings 
such as ESSID, Security, Reg domain and 
Tx power. 
Ensure APs are configured correctly. 
Try Site Survey mode to determine a more 
specific cause. 
Enable WMM in the APs. 
No PBX Response 
The handset has exceeded its 
retransmission limit with no ACK 
response from proxy server. 
Verify that proxy server IP address and 
port are properly configured. 
No Reg Domain  Regulatory Domain not set. 
Configure the Regulatory Domain in the 
handset. 
No SIP DHCP 
DHCP is configured but no valid 
SIP option 43 was found. 
Check DHCP server configuration for 
option 43 and reconfigure if required. 
No SVP IP 
Not SVP related. Deprecated (old) 
error message. 
Update handset software to 130.005 or 
later. 
No SVP Response 
Not SVP related. No handset 
License Option set. 
Set License Option to 22. See Chapter 2 
for detailed information. 










