Release Notes

© 2019, Polycom, Inc. All rights reserved. POLYCOM® and the names and marks associated with Polycom's products are trademarks and/or service marks of Polycom, Inc.
and are registered and/or common law marks in the United States and various other countries. All other trademarks are property of their respective owners.
3
4
65mm (2.6 in.)
1
6 mm (4)
Depth = 40 mm
10mm (.4 in.)
25mm (1 in.)
50 mm (2 in.)
2
Operating: 0º - 45ºC (32º - 113ºF)
Storage: -40º - 70ºC (-40º - 160ºF)
Correct disposal of this product:this symbol indicates that
this product must not be disposed of with household waste,
according to the WEEE Directive (2012/19/EU) and your
national law. This product should be taken to a collection
center licensed for the recycling of waste electrical and
electronic equipment (EEE).The mishanding of this type of
waste could have a possible negative impact on the
environment and human health due to potentially hazardous
substances that are generally associated with EEE. At the same time,
your cooperation in the correct disposal of this product will contribute to
the efficient use of natural resources. For more information about where
you can take your waste equipment for recycling, please contact your
local city office, or your household waste collection service.
Product Documentation
Documentation du produit
Documentación del producto
Documentação do produto
Produktdokumentation
www.polycom.com/support
Support
Operating: 15% - 80%
Storage: 5% - 95% non-condensing
a
b
+37.5º
-37.5º
HFOV 111º
VFOV
Screw size:4*40mm
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions :
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device. Under Industry Canada
regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired operation.