Installation Instructions
Table Of Contents
- Service Agreements
- Governing Law
- Limitations of Liability
- Polycom Limited Warranty and Limitation Liability
- Exclusions
- Warranty Exclusive
- Safety, Compliance, and Disposal Information
- Part 15 FCC Rules
- Class A Digital Device or Peripheral
- Modifications
- Radiation Exposure Statement
- Installation Instructions
- Plug Acts as Disconnect Device
- Industry Canada
- Industry Canada (IC)
- CE Mark
- Singapore
- Japan VCCI
- Operating Ambient Temperatures
- Waste Electrical and Electronic Equipment (WEEE)
- Restriction of Hazardous Substances Directive (RoHS)
- Polycom Take Back
- Copyright Information
Po
lycom, Inc. 4
Polycom Studio Safety and Regulatory Notices
Modifications
In accordance with Part 15 of the FCC Rules, the user is cautioned that any changes or modifications not
expressly approved by Polycom, Inc. could void the user’s authority to operate the equipment.
Radiation Exposure Statement
The antenna used for this transmitter must be installed to provide a separation distance of at least 20
centimeters from all persons and must not be co located or operating in conjunction with any other
antenna or transmitter. This mobile device with its antenna complies with FCC’s RF radiation exposure
limits set forth for an uncontrolled environment. To maintain compliance, this transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
Installation Instructions
Installation must be performed in accordance with all relevant national wiring rules.
L’Installation doit être exécutée conformément à tous les règlements nationaux applicable au filage
électrique.
Plug Acts as Disconnect Device
The socket outlet to which this apparatus is connected must be installed near the equipment and must
always be readily accessible.
Industry Canada
This device complies with RSS210 of the Industry Canada rules. Operation is subject to the two following
conditions:
1 This device does not cause harmful interference.
2 This device must accept any interference received, including interference that may cause undesired
operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio
exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit
pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris
un brouillage susceptible de provoquer un fonctionnement indésirable.
Industry Canada (IC)
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du Canada. Certification
Number IC: 1849C-Pano