Installation Instructions
Table Of Contents
- Service Agreements
- Governing Law
- Limitations of Liability
- Polycom Limited Warranty and Limitation Liability
- Exclusions
- Warranty Exclusive
- Safety, Compliance, and Disposal Information
- Part 15 FCC Rules
- Class A Digital Device or Peripheral
- Modifications
- Radiation Exposure Statement
- Installation Instructions
- Plug Acts as Disconnect Device
- Industry Canada
- Industry Canada (IC)
- CE Mark
- Singapore
- Japan VCCI
- Operating Ambient Temperatures
- Waste Electrical and Electronic Equipment (WEEE)
- Restriction of Hazardous Substances Directive (RoHS)
- Polycom Take Back
- Copyright Information
Polycom Studio Safety and Regulatory Notices
Polycom, Inc. 3
Safety, Compliance, and Disposal Information
● This equipment is intended for indoor use only.
● Always disconnect the system from power before cleaning or servicing.
● In order to remove all power from this unit, disconnect the power supply mains cord.
● Do not spray liquids directly onto the system when cleaning. Always apply the liquid first to a static-
free cloth.
● Do not immerse the system in any liquids or place any liquids on it.
● Do not disassemble this system. To maintain the warranty on the system, a qualified technician
must perform service or repair work.
● There are no user serviceable parts inside this product.
● This product is intended to be powered by an external (LPS) power supply - use only the type
which is supplied with this product.
● Do not use a power cord that is damaged. This could cause fire or electric shock. Contact the
manufacturer for a replacement cord, if necessary.
● Only use a power cord which is appropriately rated and approved relevant to the country of use.
● This equipment is not intended to be operated by children.
● When connecting to the mains supply, connect only to an earthed supply outlet which is installed
near the equipment and is easily accessible.
● Keep ventilation openings free from any obstructions.
● The ambient operating temperature rating of this equipment is 0 - 40ºC and should not be
exceeded.
Part 15 FCC Rules
This device is compliant with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
● This device may not cause harmful interference.
● This device must accept any interferences received, including interference that may cause
undesired operation.
Class A Digital Device or Peripheral
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.