Part No. 14168600, Ed.
Copyright © Polycom, Inc. All Rights Reserved Catalog No. 14168600 Version 2 Proprietary and Confidential The information contained herein is the sole intellectual property of Polycom, Inc. No distribution, reproduction or unauthorized use of these materials is permitted without the expressed written consent of Polycom, Inc. Information contained herein is subject to change without notice and does not represent commitment of any type on the part of Polycom, Inc.
Contents 3 Contents Chapter 1 Preface.......................................................................................................... 5 1.1 Before You Begin ........................................................................................................ 5 1.2 Chapter Overview ....................................................................................................... 5 1.3 Related Documentation ...................................................................................
14168600, Ed.
Chapter 1 Preface This guide describes the specific configuration of a KIRK Wireless Server 600v3 (KWS600v3) when using SIP Protocol. The guide is intended for qualified technicians who will install, register and configure a KWS600v3 in a SIP environment. To qualify to install the KWS600v3 Solution, you must have successfully completed the KWS600v3 technical training.
Preface 14168600, Ed.
Chapter 2 SIP Specific Configuration This section describes how to configure the KIRK Wireless Server 600v3 when using SIP Protocol. It only describes specific configuration procedures in connection with the SIP Protocol. For detailed information about installing and configuring the KWS600v3 in general, refer to the KIRK Wireless Server 600v3 Installation and Configuration Guide.
SIP Specific Configuration 2.2 Configuring DECT System When configuring the KWS600v3 in a SIP environment it is necessary to enable the check boxes; Enbloc Dialing and DTMF through RTP channel. 1 Under the Configuration menu, click DECT, and then click System. Figure 2 Adm. Page: Configuration/DECT/System page - SIP Protocol 2 Select the Enbloc Dialing check box.
SIP Specific Configuration 1 9 Under the Configuration menu, click DECT, and then click Features. Figure 3 Adm. Page: Configuration/DECT/Features page - SIP Protocol 2 Select the Enable check box to enable the Call Waiting feature. 3 Click OK. 4 Click reset required. A window appear. 5 Click OK. The Call Waiting feature is now enabled in the system. For the feature to be used, it must be activated on each handset by pressing *43# on the handset.
SIP Specific Configuration 14168600, Ed.
