User manual

Chapter 16-RMX Administration and Utilities
16-20
IP_ ENVIRONMENT
_LINK=NO
In H.239-enabled MIH Cascading, when MGC
is on level 1, setting this flag to YES will adjust
the line rate of HD Video Switching
conferences run on the RMX 2000 from
1920Kbps to 18432, 100bits/sec to match the
actual rate of the IP Only HD Video Switching
conference running on the MGC.
Note: If the flag MIX_LINK_ENVIRONMENT
is set to NO, the IP_LINK_ENVIRONMENT
flag must be set to YES.
ENABLE_H239_ANNEX
_T=YES
In H.239-enabled MIH Cascading, when MGC
is on level 1, enables sending Content using
Annex T.
ENABLE_TEXTUAL
_CONFERENCE
_STATUS=YES
Set the value of this flag to NO to disable Text
Indication. This setting is recommended for
MCUs running Telepresence conferences.
Default: YES.
SITE_NAME
_TRANSPARENCY
=YES
Set the value of this flag to NO to disable
Endpoint Name Transparency.
Default: YES.
SITE_NAMES_ALWAYS
_ON =NO
Set the value of this flag to YES to enable the
permanent display of Endpoint Names.
Default: NO.
RMX_MANAGEMENT
_SECURITY
_PROTOCOL
Enter the protocol to be used for secure
communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
Table 16-4 Manually Added System Flags – MCMS_PARAMETERS
(Continued)
Flag and Value Description