Specifications

Integrator’s Reference Manual for Polycom HDX Systems
4–252 Polycom, Inc.
pricallbycall
Sets or gets the PRI call-by-call value. This command is only applicable if you
have a PRI network interface connected to your system.
Syntax
pricallbycall get
pricallbycall set {0..31}
Feedback Examples
• pricallbycall set 1
returns
pricallbycall 1
• pricallbycall get
returns
pricallbycall 1
Comments
Call-by-call is a number from 0 to 31, which is optionally sent to an upstream
telephone company switch, if required. For example, specify a value of 6 for a
T1 PRI network interface module that is directly connected to an ATT 5ESS
switch, which is provisioned with Accunet. You must consult with the
telephone company service provider to determine whether a call-by-call value
is required for a particular PRI line. For most cases, the default value of 0 is
correct. Always use the value 0 when connected to a PBX. A non-zero value
should not be required in Europe. Values greater than 31 are reserved for
internal use and must not be used.
Parameter Description
get Returns the current setting.
set Sets PRI call-by-call when followed by a value from
{0..31} .
{0..31} Range of call-by-call values.