Specifications

Integrator’s Reference Manual for Polycom HDX Systems
4–194 Polycom, Inc.
isdnswitch
Sets or gets the ISDN switch protocol. This command is only applicable if you
have an ISDN network interface connected to your system.
Syntax
isdnswitch get
isdnswitch <pt-to-pt_at&t_5_ess|multipoint_at&t_5_ess|ni-1>
isdnswitch <nortel_dms-100|standard_etsi_euro-isdn|ts-031|ntt_ins-64>
Feedback Examples
• isdnswitch pt-to-pt_at&t_5_ess
returns
isdnswitch pt-to-pt_at&t_5_ess
• isdnswitch nortel_dms-100
returns
isdnswitch nortel_dms-100
•
isdnswitch get
returns
isdnswitch nortel_dms-100
Comments
If more than one switch protocol is supported, you must find out from your
telephone service provider which protocol to select. If you change the country
settings, a new set of ISDN switch protocols is loaded.
See Also
To set the switch type for PRI systems, use the priswitch command on
page 4-264 .
Parameter Description
get Returns the current switch protocol.
pt-to-pt_at&t_5_ess|
multipoint_at&t_5_ess|
ni-1|nortel_dms-100|
standard_etsi_euro-isdn|
ts-031|ntt_ins-64
Specifies the ISDN switch protocol to use.