Specifications

System Commands
Polycom, Inc. 4–67
Feedback Examples
• camera far 2
specifies camera 2 at the far-site and returns
camera far 2
• camera far move left
causes the far-site camera to start panning to the left and returns
event: camera far move left
continuous Selects continuous movement mode. The camera will
move in direction specified until a
camera <near|far>
move stop
command is sent. This is the default setting.
discrete Selects discrete movement mode. The camera will
move a small amount in the direction specified and
then stop. No stop command is required.
source Returns the number of the near or far camera source
currently selected.
getposition Gets the pan, tilt, and zoom coordinates of the currently
selected PTZ camera in the format of
pan tilt zoom .
setposition “x” “y”
“z”
Sets the pan ( x ), tilt ( y ), and zoom ( z ) coordinates of
the currently selected PTZ camera. Camera PTZ
range:
-880 <= pan <= 880
-300 <= tilt <= 300
0 <= zoom <= 1023
Note: Some D30 cameras might not be able to reach
the designed range limit. For example, although the
pan limit is 880, the camera might only be able to reach
860.
ppcip Specifies People+Content IP as the main video source
if it is running and connected to the system.
for-people {2..5} Sets the source for the specified camera to People.
for-content {2..5} Sets the source for the specified camera to Content.
list-content Gets a list of cameras configured as Content.
register Registers to receive feedback when the user changes
the camera source. Returns the current camera
registration state when followed by the
get parameter.
unregister Unregisters to receive feedback when the user
changes the camera source.
Parameter Description