Switch User Manual

Airespace Wireless Enterprise Platform—AireOS AS-2000 Switch Controller with AP10-xx Access Point
PN: 1725-36047-001_G.doc
5
Access Point Configuration
1. Connect to the Airespace switch or controller via Netscape or
Internet Explorer by navigating to the URL http://<IP_Addr>
(where <IP_Addr> is the IP address of the switch or controller).
2. The following table shows additional settings for the 802.11b
Network configuration. Navigate to this page by clicking the
Wireless tab at the top of the screen and 802.11b Network in the
navigation pane.
Parameter Setting Criticality
802.11b Network Status Checked Required
Data rates: 1.0 Mandatory Required
2.0 Mandatory Required
5.5 Mandatory/Supported * Required
11 Mandatory/Supported * Required
Beacon period (Kusec) 100 Required
Antenna Diversity Required
Enable short preamble Not Checked Required
* For optimum capacity, set Mandatory if handsets are all operating at 11 Mb/s and the SpectraLink 8000
SVP Server is installed.
3. Click the Apply button to save the changes.
4. Click the
Auto-RF button, to the right of the Apply button.
5. The following table shows additional parameters for the
Auto-RF
configuration. Scroll to the bottom of the page to enter these
parameters.
Parameter Setting Criticality
Noise measurement 3600 Required
Load measurement 3600 Required
Signal measurement 3600 Required
Coverage measurement 3600 Required