Specifications

C - 1
C
Status Messages
Status Display
The call status can be displayed in a number of ways. The getcallstate
(deprecated) command on page 4-98 returns a table listing the status,
speed, and dialed number of current calls.
To display real-time status on individual B channels (incoming or outgoing
calls), either register the API session with the callstate command on
page 4-30, or start an outbound call with the dial command on page 4-55.
These two commands will cause the system to re-direct the B channel status
messages to the session which has issued one of these two commands. For
example, if the RS-232 device issues a
dial command, then call status is
directed to the RS-232 port; if a later session on a Telnet port issues a
dial
command, then call status is also directed to that Telnet port.
B Channel Status Message Example
The following output example is for B channel status messages, where:
cs Indicates call status for one B channel.
RINGING Indicates a ring-in or ring-out and is equivalent to a 25% blue
sphere on the graphical user interface.
CONNECTED Is equivalent to a 50% yellow sphere.
BONDING Indicates the bonding protocol is operational on the channel and
is equivalent to a 75% orange sphere.
COMPLETE Is equivalent to a 100% green sphere.