Specifications

System Commands

4 - 175

pricallbycall

Sets or gets the PRI call-by-call value. This command is only applicable if you

have a PRI network interface connected to your system.

Syntax

pricallbycall get

pricallbycall set {0..31}

Feedback Examples

pricallbycall set 1

returns

pricallbycall 1

Comments

Call-by-call is a number from 0 to 31, which is optionally sent to an upstream

telephone company switch, if required. For example, specify a value of 6 for a

T1 PRI network interface module that is directly connected to an ATT 5ESS

switch, which is provisioned with Accunet. You must consult with the

telephone company service provider to determine whether a call-by-call value

is required for a particular PRI line. For most cases, the default value of 0 is

correct. Always use the value 0 when connected to a PBX. A non-zero value

should not be required in Europe. Values greater than 31 are reserved for

internal use and must not be used.

Parameter Description

get

Returns the current setting.

set

Sets PRI call-by-call when followed by a value from

{0..31}

Range of call-by-call values.