Specifications

System Commands
4 - 49
cts
Sets or gets the CTS serial interface control signal (clear to send) configuration.
This command is only applicable if you have a V.35 network interface
connected to your system.
Syntax
cts <get|normal|inverted|ignore>
Feedback Examples
• cts normal
• cts inverted
Comments
The default setting for this signal is
“normal” .
Parameter Description
get Returns the current setting.
normal Sets the signal to normal (high voltage is logic 1).
inverted Sets the signal to inverted (low voltage is logic 1).
ignore Ignores the signal.