Specifications

System Commands
4 - 33
Feedback Examples
•
camera far 2
causes the remote terminal to begin sending its camera 2.
•
camera far move left
causes the far camera to start panning to the left.
•
camera near move zoom+
causes the near camera to zoom in.
•
camera registered
• camera unregistered
• camera near 2
discrete
Selects discrete movement mode. The camera will
move a small amount in the direction specified and
then stop. No stop command is required.
source Returns the number of the near or far camera source
currently selected.
getposition Gets the pan, tilt, and zoom coordinates of the currently
selected PTZ camera in the format of pan tilt zoom .
setposition “x” “y”
“z”
Sets the pan ( x ), tilt ( y ), and zoom ( z ) coordinates of
the currently selected PTZ camera. Camera PTZ
range:
-880 <= pan <= 880
-300 <= tilt <= 300
0 <= zoom <= 1023
Note: Some D30 cameras might not be able to reach
the designed range limit. For example, although the
pan limit is 880, the camera might only be able to reach
860.
ppcip
Specifies People+Content IP as the main video source
if it is running and connected to the system.
for-people {2..5} Sets the source for the specified camera to People.
for-content {2..5} Sets the source for the specified camera to Content.
list-content Gets a list of cameras configured as Content.
register Registers to receive feedback when the user changes
the camera source. Returns the current camera
registration state when followed by the
get parameter.
unregister Unregisters to receive feedback when the user
changes the camera source.
Parameter Description