Datasheet

Internet and Intranet Calling with Polycom PVX 8.0.1
- 10 -
3. From the Advanced menu on the left of the page, select Port Forwarding.
4. On the Port Forwarding page, select Add Custom Service.
5. On the Ports-Custom Services page, enter the following information for the
first port in Table 1.
NetGear routers automatically pass TCP and UDP traffic through the same port. You do
not have to designate TCP or UDP when you open ports.
6. Click Apply.
7. Repeat steps 4-6 of this procedure for the remaining ports in Table 1.
8. When you have opened and assigned all of the ports in Table 1, review the Port
Forwarding page. Check that all of the ports are correct, enabled, and assigned
to the correct Server IP (internal) Address.
Linksys Routers
The following procedure applies to the Linksys BEFSX41 router. The screens and settings
may vary slightly for different Linksys models. Follow these steps to configure your
Linksys router:
In this field... Enter this information...
Service Name Any unique identifier such as “H.323 call setup”
Starting Point Port or the starting value of the range listed in Table 1
Ending Point Port or the ending value of the range listed in Table 1
Server IP Address IP address that the NAT has assigned to your computer