User`s guide

Polycom VVX Expansion Module Administrator’s Guide Addendum UC Software 4.1.6
Polycom, Inc. 59
Parameter
Permitted Values
Default
voipPort.SIP.useCompleteUriForRetrieve
0 or 1
1
If set to 1, the target URI in BLF signaling uses the complete address as provided in the XML dialog document. If
set to 0, only the user portion of the XML dialog document is used and the current registrar's domain is appended
to create the full target URI.
voipPort.SIP.useLocalTargetUriforLegacyPickup
0 or 1
1
If set to 1, BLF signaling uses the address as provided in the local target URI in the XML dialog document with
additional rules based on voipPort.SIP.useCompleteUriForRetrieve. If set to 0, the local target URI is
not considered and instead the identity attribute is used with additional rules based on
voipPort.SIP.useCompleteUriForRetrieve.
voIpProt.SIP.useContactInReferTo
0 or 1
0
If set to 0, the “To URI” is used in the REFER. If set to 1, the “Contact URI” is used in the REFER.
voIpProt.SIP.useRFC2543hold
0 or 1
0
If set to 0, use SDP media direction parameters (such as a=sendonly) per RFC 3264 when initiating a call.
Otherwise use the obsolete c=0.0.0.0 RFC2543 technique. In either case, the phone processes incoming hold
signaling in either format. Note: voIpProt.SIP.useRFC2543hold is effective only when the call is initiated.
voIpProt.SIP.useSendonlyHold
0 or 1
1
If set to 1, the phone sends a reinvite with a stream mode parameter of sendonly when a call is put on hold.
This is the same as the previous behavior. If set to 0, the phone sends a reinvite with a stream mode parameter
of inactive when a call is put on hold. NOTE: The phone ignores the value of this parameter if set to 1 when
the parameter voIpProt.SIP.useRFC2543hold is also set to 1 (default is 0).
1
Change causes phone to restart or reboot.