User`s guide

Polycom VVX Expansion Module Administrator’s Guide Addendum UC Software 4.1.6
Polycom, Inc. 58
Parameter
Permitted Values
Default
voIpProt.SIP.serverFeatureControl.localProcessing.dnd
0 or 1
1
If set to 0 and voIpProt.SIP.serverFeatureControl.dnd is set to 1, the phone will not perform local DND
call behavior. If set to 1, the phone performs local DND call behavior on all calls received.
voIpProt.SIP.specialEvent.checkSync.alwaysReboot
1
0 or 1
0
If set to 1, always reboot when a NOTIFY message is received from the server with event equal to check-sync. If
set to 0, only reboot if any of the files listed in <MAC-address>.cfg have changed on the FTP server when a
NOTIFY message is received from the server with event equal to check-sync.
voIpProt.SIP.specialEvent.lineSeize.nonStandard
1
0 or 1
1
If set to 1, process a 200 OK response for a line-seize event SUBSCRIBE as though a line-seize NOTIFY with
Subscription State: active header had been received. This speeds up processing.
voIpProt.SIP.strictLineSeize
0 or 1
0
If set to 1, The phone is forced to wait for a 200 OK response when receiving a TRYING notify. If set to 0, dial
prompt is provided immediately when you attempt to seize a shared line without waiting for a successful OK from
the call server.
voIpProt.SIP.strictReplacesHeader
0 or 1
1
This parameter applies only to directed call pick-up attempts initiated against monitored BLF resources. If set to
1, the phone requires call-id, to-tag, and from-tag to perform a directed call-pickup when
call.directedCallPickupMethod is configured as native. If set to 0, call pick-up requires a call-id only.
voIpProt.SIP.strictUserValidation
0 or 1
0
If set to 1, the phone is forced to match the user portion of signaling exactly. If set to 0, the phone uses the first
registration if the user part does not match any registration.
voIpProt.SIP. supportFor100rel
0 or 1
1
If set to 1, the phone advertises support for reliable provisional responses in its offers and responses. If set to 0,
the phone does not offer 100rel and rejects offers requiring 100rel.
voIpProt.SIP.tcpFastFailover
0 or 1
0
If set to 1, failover occurs based on the values of reg.x.server.y.retryMaxCount and
voIpProt.server.x.retryTimeOut. If 0, a full 32-second RFC-compliant timeout is used. See
reg.x.tcpFastFailover.
voIpProt.SIP.tlsDsk.enable
0 or 1
0
If 0, TLS DSK is disabled. If 1, TLS DSK is enabled. For more information, see Session Initiation Protocol (SIP)
Authentication Extensions Protocol Overview on Microsoft Developer Network.
voIpProt.SIP.turnOffNonSecureTransport
1
0 or 1
0
If set to 1, stop listening to port 5060 when using AS-SIP enabled.
voIpProt.SIP.use486forReject
0 or 1
0
If set to 1 and the phone is indicating a ringing inbound call appearance, the phone transmits a 486 response to
the received INVITE when the Reject soft key is pressed. If set to 0, no 486 response is transmitted.